七氟丙烷因其具有無色、無味、滅火效率高,而且無污染不導電的優良性能,所以大量投入到滅火系統的使用中。所以七氟丙烷滅火系統具有設計先進、性能可靠,操作簡單,環保良好等特點,在大型建筑消防滅火當中被大量采用,下面,就七氟丙烷滅火系統的使用進行介紹。
1、本品適用環境溫度為:0℃~50℃,相對濕度≤95%(40℃±2℃)。
2、保護區域的空氣中不得含有易爆、導電塵埃及腐蝕部件的有害物質,否則必須予以保護,系統不得受到震動和撞擊。
3、瓶組架必須安裝牢固。
4、操作人員須經過培訓合格后方可操作,嚴禁其他人員觸摸。
5、滅火系統噴射滅火劑前,所有人員必須在延時期內撤離火情現場,滅火完畢后,必須首先啟動風機,將廢氣排出后,工作人員方可進入現場。
6、啟動瓶、儲瓶在運輸過程中,應輕裝輕卸,防止碰撞、臥置、倒置,啟動瓶、儲瓶應避免接近熱源。
7、更換新的膜片時必須使用由我公司提供指定的供應商的產品,不得隨意用未經試驗的膜片代用。
8、在日常維護、保養或進行周期檢查時應嚴格按照操作程序,確保防止滅火劑的誤噴。
9、拆裝過程中應避免碰傷表面而影響外觀。
10、無關人員切勿亂摸亂動本系統的零部件,以免發生意外。
11、杜絕對沒有經過消防培訓的人員對本設備進行維護保養。
Sevoflurane has been widely used in fire extinguishing systems because of its colorless, odorless, high fire-extinguishing efficiency, non-pollution and non-conductive properties. Therefore, sevoflurane fire extinguishing system has the characteristics of advanced design, reliable performance, simple operation, good environmental protection, etc., which is widely used in the fire extinguishing of large buildings. The following is an introduction to the use of sevoflurane fire extinguishing system.
1. The applicable environmental temperature of this product is: 0℃ ~ 50℃, relative humidity ≤95%(40℃±2℃).
2. The air in the protected area shall not contain explosive, conductive dust and harmful substances of corroded parts; otherwise, it shall be protected and the system shall not be shaken or hit.
3. The bottle rack must be installed firmly.
4. Operators shall be trained and qualified before operation. It is strictly prohibited for other personnel to touch.
5. Before the fire extinguishing system spraying the fire extinguishing agent, all personnel must leave the fire site within the delay period. After the fire extinguishing is completed, the fan must be started and the exhaust gas discharged before the staff can enter the site.
6. In the process of transportation, the starter and storage bottles should be loaded and unloaded lightly to avoid collision, horizontal position and inversion. The starter and storage bottles should avoid approaching heat source.
7. When replacing the new diaphragm, the product of the supplier designated by our company shall be used, and the untested diaphragm shall not be used at will.
8, in the daily maintenance, maintenance or periodic inspection should be in strict accordance with the operating procedures, to ensure that to prevent the accidental spray of extinguishing agent.
9. In the process of disassembly and assembly, avoid touching the surface and affecting the appearance.
10. Irrelevant personnel should not touch the parts of the system in order to avoid accidents.
11. It is prohibited to maintain the equipment for personnel who have not received fire protection training.